WC302 Automatic Wire & Tubing Cutter

Problem	Possible Cause	Possible Solution
Material doesn’t feed properly	Feed roller not adjusted correctly	Tighten the roller feed adjusting knob clockwise to increase tension (Do not over tighten, this will cause material to jam)
Material doesn’t feed properly	Feed roller tension loss Tighten the set screw on the tension block.	Adjusting knob should turn with some friction
Display not functioning	Blown fuse	Replace with recommended fuse
	Unit not powered up	Turn power switch on, in the rear of the unit
	Incorrect voltage supplied	Make certain the incoming voltage is correct and is NOT being influenced by large equipment upstream.
Poor quality of cut or no cut	Dull or chipped blades	Dull or chipped blades must be replaced.
	Cutting Bushing worn	Rotate Cutting Bushing
	Gap between blade and cutting bushing	Loosen the cutting bushing set screw and slightly press the bushing to the blade, tighten the set screw
Erratic cut lengths	Uneven Dereeler tension	Use a power assisted dereeler at higher speeds
	Feed roller not adjusted correctly	Tighten the feed roller adjusting knob clockwise to increase tension, counter clockwise to reduce tension
	Bushing is incorrect diameter	Purchase a correct diameter bushing

Resources: WC302 Product Page; Download Operating Manual; Technical Documentation: WC302 Automatic Wire & Tubing Cutter

* Required Fields

Technical Information Center