ALSO SEE OPERATING MANUAL FOR DIAGRAMS

Problem	Possible Cause	Possible Solution
Blade stuck in the closed position	Blade hitting the head bushing	Re-Install head bushing; See “Bushing Installation”
	Blade return spring worn or broken	Remove and replace worn or broken blade return spring; See “Replacement Parts”
Material not feeding properly	Belt feed not adjusted correctly	Re-adjust belt feed tension; See “Unit Operation”
	Blade stuck in the closed position	See above PROBLEM (this table): “Blade stuck in the closed position”
	Improper size bushings	Send in sample material to Eraser for proper bushing sizing
	Uneven Dereeler tension	Make certain dereeler is functioning properly
Display not functioning	Unit not powered up	Make sure unit is plugged in & switched on
	Blown fuse	Replace with recommended fuse; See “Replacement Parts” NOTE: If fuse blows more than once, contact factory.
	Incorrect voltage supplied	Make certain the incoming voltage is correct and is not being influenced by large equipment connected to the same circuit
Poor quality of cut or no cut	Dull or chipped blades See “Blade Change/Adjustment Procedure”	Blade depth needs to be increased
	Increase the blade depth	See “Blade Change/Adjusting Procedure”
	Improper Cut Speed	Reduce or increase Cut Rate; See “Programming Batches”
	Improper Cut Time	Increase Cut Time; See “Programming Batches”
	Head bushing not installed correctly	Re-Install head bushing; See “Bushing Installation”
Inconsistent cut lengths	Uneven Dereeler tension	At high feed speeds, a power assisted dereeler is recommended
	Belt feed tension is loose	Tighten the belt feed adjusting knob clockwise to increase tension
	Improper size bushings	Send in sample material to Eraser for proper bushing sizing

Resources

WD601D Product Page

Download Operating Manual

Technical Documentation: WC601D Rotary Blade Tubing Cutter

Can’t find your answer above?

* Required Fields